Klevgrand

Insert Brusfree on the vocal track.

Select a section of the audio where only the noise is audible.

Click the 'Learn' button for 2 seconds.

Adjust the threshold to fine-tune the noise floor reduction.

Load Fosfat on the snare track.

Adjust the transient trigger sensitivity.

Select the 'Low Sine' oscillator mode.

Mix the synthesized sub-tone with the dry signal using the Dry/Wet knob.

Open AUM or Cubasis on iPad.

Load Klevgrand AUv3 plugins as inserts.

Sync parameters with an external MIDI controller.

Export the processed stems to a desktop DAW later.

Use Pipa to create a lead melody.

Automate the 'Vowel' parameter to move from 'A' to 'O'.

Apply the internal reverb and chorus.

Use the 'Formant Shift' to create otherworldly textures.

Place Grand Finale on the Master Bus.

Choose a 'Natural Loudness' preset.

Adjust the 'Impact' knob to control compression.

Check the output meter for -14 LUFS target.

Open Skaka and select a shaker type.

Draw a pattern in the internal sequencer.

Increase the 'Humanize' and 'Swing' parameters.

Automate the 'Tilt' control to change the shaker's orientation over time.

Place Kleverb before the amp sim or after the recording.

Use the noise gate settings combined with Brusfree logic.

Fine-tune the high-cut filter to remove remaining top-end fizz.

A/B test against the raw signal to ensure clarity.